How Much Does Paver Installation Cost in Wildwood, FL? (2026 Guide)
Most Wildwood paver work prices out between $12 and $22 per square foot installed, with pool decks and natural stone running higher and overlays over sound concrete running lower. A typical two-car driveway of 700 to 900 square feet lands between $9,000 and $18,000 depending on material, base depth and whether existing concrete has to come out. The variables that move a quote most are demolition, base depth and the amount of cutting a curved or bordered layout requires. Here is roughly how the numbers break out around Sumter County.
| Service | Typical Wildwood Range |
|---|---|
| Paver driveway, two-car (approx. 700-900 sq ft) | $9,000 - $18,000 |
| Driveway widening for a golf cart (2-6 ft strip) | $1,800 - $5,200 |
| Paver overlay on sound existing concrete | $9 - $16 per sq ft |
| Pool deck or lanai floor, concrete pavers | $13 - $24 per sq ft |
| Pool deck, travertine | $16 - $28 per sq ft |
| Front walkway, 4 ft wide | $14 - $26 per sq ft |
| Clean, re-sand and seal | $1.25 - $3.50 per sq ft |
| Lift and reset a settled or heaved area | $8 - $18 per sq ft, most repairs $650 - $2,200 |
What Changes the Price?
Demolition and haul-off: taking out an existing concrete driveway typically adds $2 to $6 per square foot before a single paver is set, which is why the overlay-versus-removal call is the biggest single number in most quotes.
Base depth: a pedestrian patio can sit on four inches of compacted base, a residential driveway wants six inches as a published minimum, and loose sand under a drive carrying a cart and two vehicles justifies more than that.
Cutting and pattern: a rectangular field in a running bond cuts fast, while curves, circle kits, contrasting borders and herringbone at 45 degrees all add saw time and waste that shows up in the labour line.
Material: standard concrete pavers, premium tumbled units and travertine sit at clearly different price points, and on a pool deck the choice also changes surface temperature and the cleaning routine you are committing to.
Every quote is measured on site, free, and broken out so you can see base, material, labour and any demolition as separate lines. The base specification is written on it - excavation depth, base thickness, bedding depth and edge restraint type - because that is the part you cannot inspect after the fact. If an overlay will do the job, we quote the overlay and say why, rather than pricing a removal you do not need.